Thank you for choosing the BikeSafe.me Dynamic Brake Light Controller. This compact device enhances motorcycle safety by automatically modulating brake lights to clearly alert following traffic when decelerating or braking.
Check if your motorcycle's brake light is directly wired and not controlled by the CAN-BUS. Simplest way is to check the wire to the tail light, if it is high on and low off you are good to go, if it is inverse or has some other signal your bike might have a CAN-BUS system, please consult your bike's shop manual. Current version of BrakeBright is not compatible with CAN-BUS.
Wiring Code:
Ensure all components are included upon unpacking.
Package comes with four non intrusive quick tap connectors, to provide most user friendly installation. Simply find the correct wires (either from your bike's service manual, searching online or you can use the connector to tap into a wire and check the voltage when pressing the brake).
TIP: Tap into the correct wires on the connectors' pointy end with slotted cap then use the connector cap to securely attach BrakeBright wires.
This mode requires to cut the brake light signal line. Switch side becomes the signal input (Yellow) and Lamp side becomes the output (Green). If you need to remove BrakeBright from the system, re-join the wires with a connector or solder them together.
After wiring:
Mount Position:
| Issue | Possible Cause | Solution |
|---|---|---|
| Device does not activate | Power or ground improperly connected | Verify power and ground connections. |
| Brake lights don't flash | Wiring issue with yellow/green wires | Check brake switch and lamp connections. |
| Brake lights constantly flashing | Incorrect device orientation | Verify proper mounting orientation. |
| Brake lights constantly illuminated | Incorrect yellow/green wiring | Confirm correct wiring per instructions. |
| Intermittent operation | Loose or damaged wiring | Inspect and secure all connections. |
We have developed an open source utility software to update the device firmware with latest features and improvements as they come. Please visit https://github.com/bikesafe-me/bikesafe-util for instructions and latest firmware.
To open the box you will need 1.5mm hex key or screwdriver.
BrakeBright is intended as an auxiliary safety enhancement device for motorcycles equipped with a 12V electrical system. It should not be solely relied upon as the primary means of signaling braking intentions to following vehicles. Proper installation, as outlined in this manual, is essential for the device's effective operation. Hematite Engineering Ltd does not accept liability for improper installation, incorrect usage, or any modifications performed by unauthorized persons.
While BrakeBright is designed to enhance visibility during braking and deceleration, it cannot guarantee prevention of accidents. Riders must maintain vigilance, exercise caution, and adhere to safe riding practices and comply with all applicable local laws and regulations and local traffic regulations. Firmware updates provided via the open-source platform should be performed with caution; users assume all risks associated with the modification and updating of firmware.
This device is provided as-is without any express or implied warranties, including but not limited to warranties of merchantability, fitness for a particular purpose, and non-infringement.
Always ride responsibly and stay safe.
Thank you for choosing BrakeBright
